• FIRST USE IS MOST IMPORTANT SINCE SOYBEAN WAX HAS A MEMORY.  TO AVOID FORMING A TUNNEL IN THE CENTER OF THE CANDLE YOU MUST LET IT BURN SUFFICIENTLY LONG SO THAT THE WAX MELTS TO THE EDGE OF THE POT WHICH CAN TAKE A FEW HOURS.

​​

• TO LIGHT THE CANDLE, TILT IT SLIGHTLY  THEN ALLOW THE FLAME TO IGNITE THE ENTIRE LENGTH OF THE WICK. LIKE WHEN YOU START A FIREPLACE, YOU MAY HAVE TO FIRE IT A FEW TIMES. DON'T WORRY IF YOUR WICK IS GOING OUT, THE WOOD MUST HOT BEFORE GETTING ON FIRE, THIS IS NORMAL!

​

• BETWEEN EACH LIGHTING IT IS IMPORTANT TO CUT THE WOOD WICK TO REMOVE THE BURNED PART. TO DO THIS A BIT CUTTER IS IDEAL SINCE IT ALLOWS EASILY TRIM THE BIT EVEN WHEN IT IS MORE DIFFICULT TO ACCESS. IT IS THEREFORE ENOUGH TO CUT THE WICK, LEAVING ONLY 5 MM TO LIGHT IT. IF YOU LEAVE LONGER, THE WICK MAY EXTINGUISH BY ITSELF.

​

• TO EXTINGUISH THE CANDLE, YOU JUST PUT THE COVER ON. THE ABSENCE OF AIR WILL SMOTHER THE FLAME, WHICH WILL EXTINGUISH IN A FEW SECONDS.

​

• STOP USING THE CANDLE WHEN APPROXIMATELY 1 CM OF WAX REMAINS AT THE BOTTOM OF THE CONTAINER. DON'T FORGET TO READ THE TIPS FOR THE SAFE USE OF THE CANDLES THAT ARE FOUND UNDER EACH OF THE CANDLES. ​

​

• WHEN YOUR CANDLE IS COMPLETED, SIMPLY Peel off the METAL BASE THAT IS AT THE BOTTOM OF THE JAR. YOU CAN THEN WASH THE JAR AND THE CRYSTAL IN HOT WATER AND A LITTLE DISH SOAP. YOU WILL THEN HAVE A NICE GEM TO PLACE ON YOUR NIGHT STAND OR ON YOUR WORK DESK FOR GOOD ENERGIES IN ADDITION TO A GLASS JAR THAT CAN BE USED A THOUSAND AND ONE OPTIONS, BE CREATIVE TO REUSE IT!

​

​​

​